Expert Answers about Honda Jump Starters and Jumper Cables
- NoCo Boost XL - 1500 Amp Jump Starter
- Without knowing when you bought your Noco # 329-GB50XL, I can't determine your warranty status, but I can tell you that it has a one-year limited warranty.
I looked at the Instructions-Details.PDF on our product page and there are not any serviceable parts or user replaceable fuse. That leaves you to determine if it is user error or product failure. I would consider the following trouble shooting steps. (1.) When you attempt to use the jumper do ANY lights show up on the jump starter?...
view full answer... - Why Does My Peak Battery Jumper Box Alternate Its Display From FL to 84?
- Whenever I hear of a battery giving off this type of feedback flashing from FL(fully charged) to 84(percent of charge) it tells me that the battery has lost its maximum capacity. The jumper box is alternating this as it attempts to charge and the battery says its fully charged but as the charging voltage is turned off it drops to the 84 you see as it can no longer hold a full 100% charge. The charger then kicks back on thinking it can charge back to 100.
You should replace it at this...
view full answer... - Troubleshooting 1988 Mallard Motorhome with 3 Batteries
- To be of assistance because you have 3 batteries, I will need to know how they are wired. I assume you have one battery for a vehicle start battery and then two house batteries wired in parallel. This is the most common way 3 batteries are connected in motorhomes.
It sounds like your primary start battery is being drained by your other batteries, so even when it is fully charged as soon as you connect it, it loses amperage because of the draw from the other batteries that need to be charged....
view full answer... - Troubleshooting A Stromberg Carlson Landing Gear Motor that Shuts Off After Only a Few Seconds
- The motor that is on the Stromberg Carlson Electric Landing Gear Set # LG-1 draws 30 amps. It sounds like either you have a weak ground or you are overdrawing the current wiring you are using to power the motor. You might check the wiring of both the power and ground wires you are using for the motor because it sounds like the problem lies somewhere in there.
You could try running a jumper cable from the positive side of the battery of your vehicle to the jack and the same for the ground...
view full answer... - Troubleshooting LED Clearance Lights On Semi Trailer Flashing Faintly When Using Turn Signals.
- It sounds like there may be an issue with power shorting into the clearance and running lights when you use the turn signals. As LED lights do not require a lot of power it may be the power is jumping the circuits inside your junction box. Be sure to also check for any signs of power shorting inside the trailer connector. Some Dielectric Grease # 11755 should help prevent an issue inside the trailer connector. If your power is shorting inside the junction box you can try some Liquid Electrical...
view full answer... - Trailer Left Side Running Lights Not Working All Other Lights Work
- On many trailers the running light wires are jumped from one side to the other on the trailer. This is because there is a single running light wire only ran on one side. A wire would have to be spliced in on the one side, ran to the other side of the trailer, and connected to the running lights.
If using a junction box, the one running light wire from the trailer connector can go to a single terminal and from there you can run separate wires for the running lights on each side of the trailer....
view full answer...
Go To Results